HP certification

pass4side has assembled to take you through 120 Q&As to your 350-025 Exam preparation. In the 350-025 exam resources, you will cover every field and category in 350-025 helping to ready you for your successful Juniper Certification.

Quality and Value for the 350-025 Exam

pass4side Practice Exams for Cisco 350-025 are written to the highest standards of technical accuracy, using only certified subject matter experts and published authors for development.

100% Guarantee to Pass Your 350-025 Exam

If you prepare for the exam using our pass4side testing engine, we guarantee your success in the first attempt. If you do not pass the CCIE 350-025 exam (CCIE Service Provider Dial) on your first attempt we will give you a FULL REFUND of your purchasing fee AND send you another same value product for free.

Cisco 350-025 Downloadable, Printable Exams (in PDF format)

Our Exam 350-025 Preparation Material provides you everything you will need to take your 350-025 Exam. The 350-025 Exam details are researched and produced by Professional Certification Experts who are constantly using industry experience to produce precise, and logical. You may get questions from different web sites or books, but logic is the key. Our Product will help you not only pass in the first try, but also save your valuable time.

　
　
Exam : Cisco 350-025
Title : CCIE Service Provider Dial


1. To have the router verify a called-party number in the incoming setup message for an ISDN BRI call:
A. Use isdn tei first-call
B. Include ldn on spid number line
C. Use isdn answer1
D. Use isdn caller
Answer: C

2. The network administrator has forgotten the enable password of the router. Luckily, no one is currently logged into the router, but all passwords on the router are encrypted. What should the administrator do to recover the enable password?
A. Call the Cisco Technical Assistance Center (TAC) for a special code that will erase the existing password.
B. Reboot the router, press the break key during bootup, boot the router into ROM monitor mode, and modify the configuration register so that the current configuration is ignored during normal bootup
C. Reboot the router, press the BREAK key during bootup, and boot the router into ROM Monitor mode to erase the configuration, and re-install the entire configuration as it was saved on a TFTP server.
D. Erase the configuration, boot the router into ROM Monitor mode, press the BREAK key, and overwrite the previous enable password with a new one.
Answer: B

3. While entering commands on a console, the break key is pressed accidentally and the router reboots. What action could disable this problem?
A. In configuration mode, enter disable break.
B. In configuration mode, enter no service break.
C. Change the configuration register.
D. Replace the router - this is an invalid response to pressing the break key when past 60 seconds after boot.
Answer: C

4. interface Dialer1
ip address 1.1.1.1 255.255.255.0
encapsulation ppp
dialer remote-name Smalluserdialer
string 4540
dialer pool 3
dialer-group 1
What statement about this configuration is true?
A. This interface is configured for legacy DDR and therefore cannot be used for dialer profiles.
B. This interface is a logical interface whose configuration is only used for inbound calls on physical interfaces in pool 3.
C. This logical interface belongs to a group of physical interfaces in group 1.
D. This configuration is not valid because it is missing the "dialer in-band" command.
E. This interface will use the name Smalluser instead of the router's hostname for authentication purposes when connecting to the remote peer.
F. None of the above
Answer: F

5. The configuration register does NOT retain settings for:
A. An enabled 'Break' key
B. The console baud rate
C. The boot method
D. An enabled AUX port
Answer: D

6. On a Cisco router with an external modem, what EIA 232 signal will be received by the access server to indicate the presence of an incoming call?
A. Request To Send
B. Clear To Send
C. Data Terminal Ready
D. Data Set Ready
E. Loopback
Answer: D

7. The purpose of the dialer fast-idle command is:
A. To decrease the amount of time that an interface is kept down before the next call can be placed - By default, DTR is held low for five seconds.
B. To specify the amount of time that an interface can remain idle before being disconnected when new outbound calls need to be made
C. To decrease the interdigit delay between DTMF tones when placing a call
D. To increase the rate at which disconnected interfaces become available for new outbound calls
E. To specify the regular idle timeout for high speed non-async interfaces
Answer: B

8. What command is used to set the length of time a non-ISDN interface stays down after a call has been completed or has failed and before it is available to dial again?
A. dialer enable-timeout
B. dialer holddown
C. dialer fast-idle
D. dialer idle-timeout
E. dialer wait-for-carrier-time
Answer: A

350-025 Downloadable, Interactive Testing engines

We are all well aware that a major problem in the IT industry is that there is a lack of quality study materials. Our Exam Preparation Material provides you everything you will need to take a certification examination. Like actual certification exams, our Practice Tests are in multiple-choice (MCQs)

Our Cisco CCIE 350-025 Exam will provide you with exam questions with verified answers that reflect the actual exam. These questions and answers provide you with the experience of taking the actual test. High quality and Value for the 350-025 Exam:100% Guarantee to Pass Your CCIE exam and get your CCIE Certification.

 

Cisco News

Free 350-025 pdf demo download
Cisco 350-025 exam Title : CCIE Service Provider Dial It is well known that 350-025 exam is the hot exam of Cisco certification. TestInside offer you all the Q&A of the 350-025 real test. It is the examination of the perfect combination and it will help you pass 350-025 exam at the first time! Download Testinside free 350-025 demo: 1. What command is used to set the length of time a non-ISDN interface stays down after a call has been completed or has failed and before it is available to dial aga…  [ more.. ]